Motion CM-35 Manual página 12

M O TI O N CM - 3 5 E LE CT RON IC C UR TA IN M O T O R
14 Single select 15 channel remote
Single select makes it possible to activate program mode on a single blind through a
remote control, without having to physically press the program button on the blind.
To activate Single
14.1
select simultaneously
hold the center
button and press the
pair button.
14.3
1 1 1
Once a blind is found
the channel number
will flash and the
blind starts stepping,
indicating that
program mode has
been activated. The
blind can now be (un)
paired to the remote
and/or programmed.
22
1
The remote starts
14.2
searching for blinds
+
(search mode). This
is indicated by the
horizontal bars on the
remote.
14.4 14.5
1 1 1
To search for To exit Single
the next blind select press
press the right the right
button. Search button during
mode will be search mode.
activated. The display
shows the
To find the
previous blind letter O.
press the left
button.
15 Channel select 5 channel remote
Channel select makes it possible to copy blinds in between channels/remotes without having
to physically press the program button on the motors.
Select the channel
15.1
from which the
1
blinds must be
copied.
15.3
All blinds in the selected
channel will start
stepping, indicating
program mode has been
activated. All blinds
can be copied to a new
channel on the same
remote or other remote.
Select a new channel on
the (new) remote.
16 Channel select 15 channel remote
Channel select makes it possible to copy blinds in between channels/remotes without having
to physically press the program button on the motors.
Select the channel
16.1
you would like to
copy.
16.3
1 1 1 1
All blinds in the selected
channel will start
stepping, indicating
program mode has been
activated. All blinds
can be copied to a new
channel on the same
remote or to other
remotes. Select a channel
on a (new) remote.
M O T I O N C M -3 5 E L EC TR ONI C C U R TA I N MOT OR
To activate
15.2
channel select
simultaneously
hold the channel
selection button
and press the pair
button.
Press the pair
15.4
button on the (new)
remote to pair the
blinds to the new
channel.
1 1 1 1
To activate
16.2
channel select
simultaneously hold
the channel selection
button and press the
pair button.
3 3 3 Press program 3
16.4
button on the (new)
remote to pair the
blinds to the (new)
remote.
+
To exit channel
15.5
select go back to the
channel selected at
step 15.1 and repeat
step 15.2
23
1 1
3 3 3 3
+
3 3 To exit channel
16.5
select choose
the channel you
selected at step 16.1
and repeat step 16.2