Safety Devices; Residual Risks; Rotating Parts - PEDROLLO MAGNIFICA Serie Instrucciones Originales De Uso

• Install the equipment away from heat sources in a dry, covered place in accordance with the specified degree of protection
(IP).
• Only qualified technicians who are aware of the safety regulations in force may carry out any installation and/or mainte-
nance work.
• Scheduled maintenance should be carried out and damaged or worn components should be replaced promptly. Only
original Pedrollo spare parts supplied by an authorised dealer or by the company itself must be used.
• Use of non-original spare parts, tampering or improper use will void the product warranty.
• The manufacturer may not be held liable for damage due to improper use of the product or caused by maintenance or
repairs carried out by unqualified personnel and/or using non-original spare parts.
During the first installation and when carrying out maintenance, make sure that:
• THERE IS NO VOLTAGE on the mains supply;
• the power supply network is equipped with protection and, in particular, with a high-sensitivity residual current circuit
breaker (≤ 30 mA in class A) suitable for protection against alternating, pulsating single-pole, continuous, high-frequen-
cy fault currents. Check that earthing complies with standards;
• after carrying out the electrical connection to the system, check the settings on the electrical panel as the electric pump
may start automatically;
• the system IS NOT PRESSURIZED
The EN 60335-2-41 standard requires that:
– the pump must be powered by a differential switch with a rated differential current not exceeding 30 mA.
– the electric pump must be fitted with a rubber power cable no lighter than "H07 RN-F" (designation 245 IEC 66).
This appliance must not be used by children or persons with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless supervision and instructions have been given.
Children should be observed to make sure they do not play with the equipment.

SAFETY DEVICES

Contact with moving parts and live components is prevented by the structure of the device itself.

RESIDUAL RISKS

Falls from the machinery
The pump has been designed to be lifted manually, without the need for any equipment. Pay attention to the possibility
of breakage or injury caused by falling equipment. Handling of the pump should be carried out using suitable footwear.

Rotating parts

During normal operations, all rotating parts are protected against accidental or incidental contact; these protections can,
however, be removed (e.g. fan cover).
The following is recommended:
• All maintenance operations should be carried out with the system switched off, providing protection against automatic
restarting.
• All protections should be reinstalled once the work has been completed.
20 | ENGLISH