Temper KCB-240 Manual De Instrucciones página 16

KCB 240-ST
Battery Crimping Tool
The detail of the charging information, please refer the manual (MANUAL FOR
CHARGER)
The battery can be used for hundreds of times, when the life span reduced obviously,
change to a new battery please.
Please charging the battery in time to avoid it to be used up absolutely; otherwise it will
become useless forever. if the battery not be used for a long time, it will discharge
automatically, so take out the battery from the tool and make sure to charge it one time
per/each quarter.
2. Usage of the tool
1. LCD board instruction:
2. LCD board showing and setting:
Please note: tool in power off , there is no any data showing.
Power on
Press
keyboard showing all the data for 1 s, then the tool on the self
inspecting for 1 s. the data will show last record, the tool is
ready for working.
for 3 s, the tool into starting status, the
Exchange the
In the power on status, press
data
Set the output
Press for 3 s enter into setting status, the data display
force
by twinkling. Press the
by 10 KN (or 5 KN, according to required), this action is
circulated from Min KN to Max KN. Press
leave it 15 s, it return to initial state.
Convenient in dark enviroment working, with a light symbol
LED set
showing on the LCD, long press button
status. display, and lighting. LCD background
lighting, meanwhile press the power button, the front LED
lighting, after 20 s, the light turn off automatically. During
LED lighting, keep for pressing
even for the LCD background light.
Battery power
full power.
,
meanwhile flash and buzzing according to the flash
frequently .Do charge the battery in time.
Error showing Error happened, such as motor damaged, drive system error
and hydraulic system problem... the tool stop working. LCD
showing ―error data‖ as following: it stands for ―over power
capacity‖
, the data exchange
per time, output data increase
for 3 s or
to get into start
to turn off the LED
www.grupotemper.com