Troubleshooting - Temper KCB-240 Manual De Instrucciones

KCB 240-ST
Battery Crimping Tool
6. If the tool not used for a long time, please make sure the piston stay on its starting
position, clear up the tool and paint the rustproof oil both to the tool piston and
accessories. Take out the battery and put them into box and store the tool in a dry
surrounding. As following:

TROUBLESHOOTING

FAULT ANALYSIS
1. Dirt, contaminants,
etc in ram area of
A. Tool tool.
is inoperative 2. The battery run out
3. Tool components
worn or damaged.
B. No power
1. No oil
during
2. Dirt, contaminants
operation or
inside of oil sac.
not up to the
3. Inner leakage
rated power
C. Leakage on
the cutting 1. Worn on the sealing
head o kits
plunger
D. Running of 1. No oil in the oil sac
the motor but 2. Air into
no power hydraulic system
output 3. Cold oil
E. Error alarm 1. No power of the battery
SOLUTION
1. Clean hydraulic system
2. Charging the battery
3. Return tool to manufacture or
distributor
1. Fill oil
2. Return tool to manufacture or
distributor
3. Return tool to manufacture or
distributor
1. Return tool to manufacture or
distributor
1. Fill or change the oil
2. Return tool to manufacture or
the
distributor
3. Use the tool under -20℃-40℃
1. The battery need to charge
www.grupotemper.com