Operation; Setting Up Your Lawn Mower; Installing The Grass Collection Box; Setting The Cutting Height - STERWINS ELM2-36P-3W.4 Instrucciones De Montaje, Utilización Y Mantenimiento

ES

5. OPERATION

PT
DANGER! Risk of injury due to electric shock.
EN
IT Warning! Do not plug in before installation is fully completed!
Caution! Do not touch rotating blade!

Setting up your lawn mower

Set up the lawn mower on flat and firm ground to ensure safe and sturdy operating.
Put the upper handle
lower handle
Move the lower handle
handle .Align the hole location of the upper handle
9
it with a quick clamp
Attach the power cord to the upper handle
Risk of death by electrocution or electric shock or serious personal
injury if power lines or electric cords are contacted. Never operate
mower over electrical sources, cords, or wires.
Adjust the handle height
There are three different handle gears on the side of the lower handle
If the height seems too tall or too short, open the quick clamp
handles , adjust the upper handle
9
the lower handle

Installing the grass collection box

Before installing, make sure the grass box has been properly attached to the metal grass
collection box
Lift the rear discharge door
with handle side up into the grooves under the hinge of the rear discharge door
sure that the hooks rest properly inside their respective grooves.
After stopping , lift the rear discharge door

Setting the cutting height

When shipped,the wheels on the mower are set to a low-cutting position.Before using the
horizontally on the ground,then open the quick clamp
3
.
9
to the proper gear.Tighten the quick clamp
9
, then fasten the clamp.
5
.
9
frame via the clips around the mouth of the box.
7
. While holding the door open, place the grass collection box
8
to the lower handle
3
with a wire clip
3
properly ,then,tighten the quick clamp
3
, take the grass collection box
8
56 56
5
to secure the lower
5
. Assemble
9
.
4
to vary the height.
9
on the side of the lower
5
to secure
5
, making
8
away.
7
of the
7