Cleaning And Maintenence - MaxPro PROFESSIONAL 113-0101 Manual

Transport setting( figure 9 )
When transport the machine, only carry the machine in transport position . If not carried in transport
position parts from the machine can be damaged.
- Unlock the transport position, firmly grip the handle (1) and press the handle(1) a little downwards, pull
out the transport locking knob (15) out. The handle (1) will now raise by spring force. There for always
guide the handle(1) when the lift to high position.
- Lock in transport position, firmly grip the handle (1) and press the handle(1) downwards till it maximum
position, push the transport locking knob (15) in , if the lock knob (15) not can be pushed in far enough
then release the handle (1) a little in upwards direction while still pushing the transport locking knob (15)
until the handle will locked.
Depth limiter( figure 10 )
The depth limiter prevents the cut-off wheel from contacting the workbench or floor. When a new wheel is
installed or when the cutting wheel not can cut trough the material , set the depth limiter as followed.
-Increase the depth limitation, loosen the lock nut (17a) a so far that the depth limiter bold(17) can be set.
press the handle (1) downwards till the desired depth has been reached. Now turn out the depth limiter
bolt (17) till the stop plate (17b) touch the limiter bolt (17). Now secure the lock nut (17a).
-decrease the depth limitation, loosen the lock nut (17a) a so far that the depth limiter bold(17) can be set.
Turn in the depth limiter bolt a few rotations and press the handle (1) downwards till the desired depth has
been reached. Now turn out the depth limiter bolt (17) till the stop plate (17b) touch the limiter bolt (17).
Now secure the lock nut (17a)
OPERATION
- Hold the handle (1) firmly. Switch on the tool and with the switch button (3) wait until the wheel attains
full speed, if desired the switch can be locked by pressing the lock on button (4)
-Lowering the cutting wheel gently into the cut by pressing at the handle (1)
-When the wheel contacts the workpiece, gradually bear down on the handle to perform the cut.
-When the cut is completed, switch off the tool by release the switch on/off button (3) in case the lock on
function is used only press and release the switch on/off button (3) without pressing the lock button (4)
-WAIT UNTIL THE WHEEL HAS COME TO A COMPLETE STOP before returning the handle to the fully
elevated position.
Caution
• Proper handle pressure during cutting and maximum cutting efficiency can be determined by the amount
of sparks that is produced while cutting. Your pressure on the handle should be adjusted to produce the
maximum amount of sparks. Do not force the cut by applying excessive pressure on the handle. Reduced
cutting efficiency, premature wheel wear, as well as, possible damage to the tool, cut-off wheel or
workpiece may result.
CLEANING AND MAINTENANCE
Important! Maintenance, cleaning and repair work may only be carried out after the machine is protected
against accidental starting by pulling the mains plug.
Repair and maintenance work on the electrical system may only be carried out by a qualified electrician.
A qualified repair technician must perform any tool service or repair. Service or maintenance performed by
unqualified personnel could result in injury. Use only identical replacement parts. Use of unauthorized
8 GB