Cleaning And Maintenance - Fromm & Starck STAR ATFE 12 Manual De Instrucciones

• Reminder function:
a. To activate the reminder function, press A –ON or on will be displayed.
b. Two seconds later, press ▲ or ▼, to set the reminder time only when the
display screen is flashing. The default reminder time is 45 minutes, displayed
as ⁻̱ 4 5. Press any button to save the time setting, or wait 5 seconds for the
system to save the time automatically. During the countdown, any operation
will restart the clock. When the countdown is complete, the display will
show⁻̱ 0 0, and the buzzer will beep for 10 seconds.
c. Within the 10-second reminder signal, press any button to reactivate the
timer that was set (point b). If no action is taken during the 10-second
reminder signal, another reminder signal will sound after 5 minutes. If there
is no operation during the second beep, the position change reminder
function will be deactivated.
d. To deactivate the position change reminder function, press and hold A for
three seconds. The LED display will show OFF or oFF.
• Collision avoidance settings:
a. To set anti-collision sensitivity, press and hold ▲ and ▼ simultaneously for
5 seconds. There are 4 levels: A-3, A-2, A-1, A-0.
b. Anti-collision sensitivity on the display: A-0 the anti-collision sensitivity
function is disabled, A-1 – low sensitivity, A-2 – medium sensitivity, A-3 – high
sensitivity. The default setting is A-3.
c. When the desktop comes into contact with another object while the height
is being adjusted, it will stop immediately and retract to avoid damage.
d. Press and hold ▲ and ▼ simultaneously for 5 seconds. If the above code
does not appear on the display, the anti-collision function is inactive.
• To reset:
a. If ASꓩ or rSt is displayed on the screen, press and hold ▼. The desktop will
move to the lowest or highest position, and then move in the opposite
direction until it stops. When the display shows the height, release the▼
button. Once reset, the desk can be used normally.
b. When an error code occurs, short press ▼, in order to move to the ASꓩ or
rSt status, and perform the resetting operation (as in step a).
c. If the desk still does not function properly after the above steps have been
completed, please contact Customer Service.

3.4. Cleaning and maintenance

a) Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.