English • Owner´s manual
Temperature
<0º C
0ºC - 10º C
10ºC - 20º C
>20º C
NOTE: When it is very cold, it may be necessary to repeat the initial steps.
Electrical start
GY 53LME Model
1. Guide the gas throttle through the electric starter unit as shown in figure 5a.
2. Insert the throttle cable into the engine brake le-ver (3) using a plier. (fig. 5b-5c)
3. Secure the electric starter unit (18) using the screws (f ) on the upper push bar (4). (fig. 5d)
• Ensure that the ignition cable is connected to the spark plug.
• Stand behind the mower. One hand squeezes the engine brake lever (3) to the handle, the other pulls the pull start.
• Start the engine using the reversing starter (17). To do this pull the handle approx. 10 – 15 cm (until you feel a resistance)
and then start the engine with a sharp pull. If the engine does not start, pull the handle again.
• Due to protective coating on the engine, a small amount of smoke may be present during the initial use of the
product and should be considered normal.
Pulsations
2±3
1±2
0±1
0
23