Device Reset - Beninca hoop Manual De Instrucciones

OFFLINE MODE
Operating mode suitable for isolated situations in which the gateway does not
have an internet connection.
All users have the same privileges.
Programming functionality limited by the fact it is impossible to have an inter-
net connection, communication between the HOOP gateway and the apps takes
place via local network (see Fig. 9). In the cloud server the association is only
saved* of the serial number of the gateway with the user and/or installation
technician account. No configuration or operating data.
(*) Only when the smartphone manages to connect to internet.
SYSTEM USE:
Having completed configuration, you can use the
system via the BeMOVE app.
After logging in, the user will access the Home page
where the grey lines identify the gateways and the
white ones the associated devices.
Simply press on the name of the device to enter
the command. If the device is a two-directional type
(only 868 MHz or cabled to the gateway) there will
be a dot on the right hand side of the screen, after
the name: a grey dot identifies the status as closed/
off; a yellow dot identifies the open/on status; a grey dot with exclamation
mark identifies the device is not reachable.
The time used by the system to notify the change of status of the device depends
on the manoeuvre time of the automation and the transmission speed of the data
24
via internet or local network.
You can edit the settings both of the gateways and the devices using the specific
button at the start of each line
The app uses pop-up messages to provide precise feedback to the user during
operation. According to the operating mode set for the gateway selected, the
side menu will allow advanced programming operations.

DEVICE RESET:

Attention!:
Resetting brings HOOP to default conditions, all users and all configura-
tions and associated devices are deleted.
1. Disconnect the HOOP gateway: the power supply led switches off.
2. Keeping the HOOP gateway button pressed, re-power
switches on with a fixed red light and the central led begins to flash in yellow
every 0.2s. Keep the button pressed for approx. 5s, until the central led slows
flashing and passes to once per second
3. Release the button by re-pressing it for a further 5s: the central led starts to
flash alternating green/red every 0.2s.
4. After 5s, the central led switches on to become a fixed yellow colour for about
7s , at this point release button
3
- if deletion was successful the led switches on a green
colour for 3s and then switches off;
- if deletion was not successful the led switches on a red colour
for 3s. In this case, repeat the procedure.
5. Disconnect power to the HOOP gateway and then power again.
ATTENTION: if you press the button after powering, the gateway will not enter
1
.
: the power supply led
1
.
2
. In the end:
2