Signalling Led - Beninca hoop Manual De Instrucciones

the correct mode. In these cases, repeat the procedure from point 1 paying
attention to press the button well before re-connecting the power supply.
2 ATTENTION: if you release the button before the 5s are up, the gateway will
not enter the correct mode. In these cases, repeat the procedure from point 1,
paying attention to flashing of the leds.
ATTENTION: do not disconnect power to the HOOP gateway during this phase.
3
If this should happen, repeat the procedure from the start.
HOOP IDENTIFICATION
Each HOOP device has an identification label.
The position of the label is highlighted in Figure 3.
The label contains the SSID of the device, the Password and Serial Number.

SIGNALLING LED

There are 3 signalling LEDs:
WiFi/LAN (green only):
1) HOOP gateway not configured (wifi not enabled): led off.
WiFi
868/433 POWER
2) Access Point mode enabled: off 1 second, on 1 second. IT should be enabled
/LAN
during the system installation phase - direct connection of the smartphone
and gateway.
3) HOOP gateway in connection to WiFi/LAN network: off 250 ms, on 250 ms.
4) HOOP gateway in connection to server via internet (only if set in OPEN or
SECURITY mode): off 125 ms, on 125 ms.
5) HOOP connected to the server or the WiFi/LAN network: led always on.
868/433 (RGB led):
1) Green led on for 2 seconds: indicates dispatch of a radio command 433 or
WiFi
868/433 POWER
868.
/LAN
2) Red led on for 2 seconds: indicates dispatch of an 868 command for which a
response was not received from the intended g.MOVE.
3) Blue led on for 2 seconds: indicates receipt of the status change of the g.MO-
VE module inputs.
4) Green and red alternating flashing leds: start the reset procedure of the devi-
ce in progress. After approx. 10 seconds of alternating, continuous flashing,
the led switches on orange for 7 seconds and then:
- the led turns fixed green for 3 seconds if the procedure is successful.
- the led turns fixed red for 3 seconds if the procedure is not successful. Repe-
at the reset procedure.
5) the white led flashing for 2 second periods: internal procedure error. YOU
need to reset the gateway and re-configure it.
POWER (red colour only):
the led switches on with the light fixed when the gateway is powered correctly.
WiFi
868/433 POWER
/LAN
EN
25