Kenwood MultiPro XL Weigh+ Instrucciones página 11

27
Blend-Xtract 2GO
a
Dispensing lid
b
Bottle
c
Sealing ring
d
Blade assembly
1 Add ingredients to the bottle up to the
400ml level mark.
For best blending performance always add
ice/frozen ingredients to the bottle first.
When adding frozen ingredients (i.e. frozen
fruit, yoghurt, ice cream or ice) do not blend
more than 60g or 3 ice cubes.
Do not blend frozen ingredients without
liquid.
2 Fit the sealing ring to the blade unit, ensuring
the seal is located correctly in the grooved
area.
Leaking will occur if the seal is damaged or
incorrectly fitted.
3 Hold the underside of the blade unit and
lower it onto the bottle, blades down.
4 Screw the blade holder onto the bottle - turn
clockwise to lock.
Shake to disperse the ingredients.
Place the blender onto the power unit and
turn clockwise to lock.
5 Select maximum speed. Allow the ingredients
to blend until smooth.
Once your drink has reached the desired
consistency, you can use the pulse (P) to
ensure all ingredients are thoroughly blended.
Hints and Tips
Note that when the bottle is filled to max
capacity (400ml), this is approximately two
servings.
If you do not intend to consume your drink
immediately, keep it refrigerated.
Ensure your drink is thin enough to be able
to drink from the dispensing lid. To make a
thinner drink add more liquid.
After blending, some drinks may not be
completely smooth due to seeds or the
fibrous nature of ingredients.
Some drinks may separate on standing,
therefore it is best to drink them straight
away. Separated drinks should be stirred
before drinking.
When the dispensing lid is fitted always keep
the bottle upright.
Using the drinking lid
1 Fit and lock the lid by turning clockwise.
2 When you want to drink, simply flip open the
lid cover. The drink can be consumed straight
from the bottle.
(if supplied)
6
28
Juice Extractor
a
Pusher
b
Juicer lid
c
Pulp remover
d
Filter drum
e
Bowl
f
Juicing spout
To use the juice extractor
1 Fit the juicer bowl to the power unit, turn
clockwise until it locks - the spout should
be situated to the left side when the bowl is
fitted correctly.
2 Place the pulp remover into the filter drum -
ensuring the tabs locate with the slots in the
bottom of the drum.
3 Fit the filter drum
4 Fit the attachment lid - turn clockwise until
it locks. Your juicer will not operate if the
bowl or lid are not fitted correctly into the
interlock .
5 Place a suitable glass or jug under the juice
outlet.
6 Cut the food to fit the feed tube.
7 Switch on and push down evenly with the
pusher - never put your fingers in the feed
tube. Process fully before adding more.
After adding the last piece, let the juicer run
for a further 30 seconds to extract all the
juice from the filter drum.
Important
If the juicer starts to vibrate, switch off and
empty the pulp from the drum. The juicer
vibrates if the pulp becomes unevenly
distributed.
Some very hard foods may make your juicer
slow down or stop. If this happens switch off
and unblock the filter.
Switch off and clear the pulp collector
regularly during use.
Hints and Tips
Before processing remove stones and pips
(eg pepper, melon, plum) and tough skins
(e.g. melon, pineapple). You do not need to
peel or core apples and pears.
Use firm, fresh fruit and vegetables.
29
Express Dice
a
Adjustable disc - dicing setting
b
Dicing grid
c
Dicing pusher
Important:
The dicing position on the adjustable
slicing disc is designed only to be used with
the dicing attachment.
(if supplied)
(if supplied)