Airwheel H3TS+ Manual Del Usuario página 18

9.Rear support leg (optional)
9-1
Install the rear support: press and hold the rear support button (Figure 9-1), insert the rear support into the reserved
hole (Figure 9-1), and release the rear support button after clamping, the installation is complete; Disassembly rear
support: Press and hold the rear support button and pull out the support at the same time.
Note: When the rear support wheel is installed downwards, it can be used as an anti-roll wheel (Figure 9-3); when the
rear support wheel is installed upwards (Figure 9-2), it can be used as a rear support. See the final use of the foot (Figure
9-4).
Reserved hole
Rear support button
9-2
Anti-roll wheel
9-3
Rear support
Rear support
- 15 -
9-4