Airwheel H3TS+ Manual Del Usuario página 20

3.After the pairing is successful, the green light flashes quickly. After a few seconds, turn on the wheelchair and enters
the remote control mode. Now the remote control stops flashing, and it lights 0.5s and then goes off.
How to use the blutooth remote control
1. Push the joystick, it could control the wheelchair to run, stop and turn normally, and the remote control indicator
light goes off, short press the "upper side big button", the horn sounds, short press the "downside big button", the
headlights turn on; The green light flashes once every 5 seconds when it is in remote control mode.
2. Short press button"C", the wheelchair switches to highest speed (5), and press button"D", the wheelchair switches
to lower speed (2).
3. Short press or long press "Power button" and release, the wheelchair joystick light will be off and power off, then
short press or long press "Power button" and release, the wheelchair will automatically turn on within 3~5 seconds;
4. After the above steps, short press or long press the "power button" and release, the wheelchair will be turned off.
At the moment, press and hold the "B" button, the wheelchair automatically enters the folding mode and starts to
fold, then release the button and short press "B", the folding pauses . and then short press "A", the wheelchair will
be unfolded. After the expansion is completed, short press the "@" button, the wheelchair exits the folding mode,
the joystick turned off and the light is off.
Bluetooth remote indicator
1. Short press or long press "Power button" and release, the wheelchair is power on, long press "@" button, after a few
seconds, the red light flashes once, it exits the remote control mode and goes to sleep mode;Short press the "Power
button", the remote control will wake up, the green light will flash quickly, the remote control will automatically
connect the wheelchair after a few seconds, and the wheelchair will automatically turn on.
2. After power on, push the Bluetooth remote joystick and release, from now on, about 2 minutes later, the remote
control automatically enters the sleep state, and the red light flashes once.
3. When the dry battery voltage is lower than 2.1V, the Bluetooth remote control will be in a low battery state, and the
red light will continue to flash.
- 17 -