Main Power Switch - Airwheel H3TS+ Manual Del Usuario

Installation and usage
1. Battery disassembly instructions
When removing the battery case, first make sure that the main
power switch is off. Unplug the battery bus connector (as shown
in Figure 1-1), press the spring clip and pull out the battery case
(Figure 1-2); when the battery is installed, insert the battery box
directly until the spring clips the battery box, then put Insert the
battery bus plug into the battery bus jack.
Note:
1.
Pay attention to the front and back of the battery case, and the
side with the sticker facing up.
2.
When the battery bus is plugged in and out, please align the
card slot with the protrusion (as shown in Figure 1-3).
3.
Do not touch the main wires and charging port with metal
objects when the main battery switch is turned on, to prevent
damage to accessories and danger.

2.Main power switch

When the indicator is on, H3TS+ is powered on, and when it's off,H3TS+ is powered off.
Tip: Please turn off power to prevent the battery from over-discharging if riders don't use it.
1-1
1-3
- 6 -
Main power
switch
shrapnel
bus plug
1-2
top sticker
bus bump