Huawei Q2 Pro Guia De Inicio Rapido página 14

If the page prompts "Unable to retrieve configuration from old router", ensure
that the power supply of the old router, and the Ethernet cable connecting
the WAN port of the old router to the LAN port of the new router are all well
connected, then restart the old router and touch TRY AGAIN.
If the problem persists, restore the router to its factory settings and follow the instructions
in this guide to reconnect the cables and re-configure the router.
6.
How to restore the base and satellite routers to factory settings?
Plug the router to a power supply and wait for a few moments until the startup
is complete, then use a PIN to press and hold the RESET button on the router
for approximately two seconds until the indicator goes out. If the indicator turns
steady red after the router restarts, the router is restored to its factory settings.
If the base router is restored to its factory settings, you would need to reconfigure it, and
then restore all satellite routers to their factory settings as well.
7.
Do satellite routers require reconfiguration after a factory reset?
The satellite router that comes in the pack is plug-and-play and does not need
to be reconfigured after a factory reset.
However, satellite routers that are purchased separately must be reconfigured
through the HUAWEI SmartHome app.
8.
How do I connect an add-on Huawei router (with H/Hi button) to my HUAWEI
WiFi Q2 Pro's network?
Wired connection. Connect the WAN port of the add-on router (new or factory
reset) to the LAN port of the base router using an Ethernet cable.
10