Instructions For The Installer; Electrical Connection; Gas Connection - CrissAir CCB 04 G5 Manual De Instrucoes

Instructions for the installer

Installation
This appliance is not provided with a
combustion product discharge. It is
recommended that it be installed in
laws in force. The quantity of air which is
necessary for combustion must not be
power.
See table of burner power.
Note: the device is in installation class 3.
The appliance's adjustment parameters
are shown on the plate attached to its
housing.
Positioning
into a working area as illustrated
around the entire periphery of the hole
cut in the worktop.

Gas connection

cylinder or to the installation according
to the prescribed standards in force, and
ensure beforehand, that the appliance
matches the type of gas available.
Otherwise, see "Adaptation to various
types of gas".
falls within the values described on the
table: "User chacteristics".
Rigid/semi rigid metal connection
so as to obtain counter stress the inner
parts of the appliance.
N.B. - when the installation has been
carried out, check the perfect sealing of
the entire connection system, by using
a soapy solution.

Electrical connection

connection, please ensure that:
• the plant characteristics are such as
to fol- low what is indicated on the
•
earth connection, following the
standards and law provisions in force.
The earth connection is compulsory
in terms of the law.
Should there be no cable and/or plug on
the equipment, use suitable absorption
material for the working temperature as
Under no circumstance must the cable
reach a temperature above 50°C of the
ambient temperature.
If connecting directly to the mains
EN