Grouw 18224 Manual De Instrucciones página 69

Saw blade (Fig. G)
Place the inner fl ange (10) over the motor
shaft.
Attach the saw blade (11), the outer fl ange
(9) and an M20 nut to the motor shaft.
Hold the outer fl ange tight with one spanner
and tighten the M20 nut using the other
spanner.
NB! Make sure that the arrow on the saw
blade points towards the sawing area.
NB! Keep the spanners in a safe place for
future use!
Outer blade guard (Fig. H)
Attach the outer blade guard (7) to the inner
blade guard (5) using four M5×10 Phillips
screws and four washers.
Return spring and chain (Fig. I)
Remove the split pin and washer from the
guide bar (17).
Tilt the cradle (4) in towards the frame (2)
until the guide bar can be inserted into the
bracket on the rear right leg.
GB
69