Working Environment; Initial Assembly; Operations Start Procedure - Kamikaze KV380 Manual Del Usuario

• Make sure the characteristics of the charger and the battery are aligned before starting to charge.
• The red LED light on the charger indicates that the battery is charging, the green LED light indicates
that it is fully charged. The approximate charging time is 3 to 5 hours (charging time for 3 fully
discharged batteries at the same time), do not keep the batteries connected longer than necessary, as
they may damage them.
• The charger has three out puts, it can charge up to 3 batteries at the same time. The charging time is
proportional to the number of batteries connected and the state of their charge. Monitor the charging
time through the LED indicator (red light charging, green light charge complete).
• Disconnect the battery charger connectors from the batteries when charging is complete.
• Make sure the battery is recharged at least every 3 months during storage periods. Do not store the
machine with the battery connected

11 Working environment

• Keep temperature of environment at 10°C ~ 22°C when charging battery, 0°C ~ +45°C when battery
is working.
• Keep tool at temperature of 0°C ~ +60°C when working
• Do not use in explosive atmosphere or near flammable substances or gases.
• Do not use in case of rain or on wet branches

12 Initial assembly

Check that the pruning shears and batteries are clean and dry, then insert the battery into the
appropriate housing according to the following image.

13 Operations start procedure

Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
81