Cutting Instructions - Kamikaze KV380 Manual Del Usuario

loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touching it, otherwise blade will hurt your body.
•
Press the power switch. After warning tone, please pull the trigger two times without holding.Do not
overload cutting, it will protect pruning shear and battery is not damaged. Do not cutting over the
dimension specified in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume maximum
position.
Caution: Do not sway the pruner from the left to right in order not to damage the edge of
blade during the resume process of blade.
Check the working frequency of the blade to verify the good working condition.

14 Cutting instructions

Wear suitable work clothes such as boots with non-slip soles, sturdy long trousers, gloves and goggles.
Wear protection gloves
Wear eye protection
Risk of cutting and severe injuries
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
• When ready to cut, place the blade on the branch to be cut and press the trigger:
• When operating the tool, keep the other hand and any other part of your body at a minimum distance
of 15cm from the blade:
82