Waring Commercial BB255E Manual De Instrucciones página 6

OPERATION
1. Before starting, make sure that the blender
is unplugged.
2. Always be sure container is properly
assembled before adding ingredients.
3. Put ingredients into container and cover it.
Do not fill above MAX FILL line.
4. With the switch in the OFF (O) position, place container on
blender base. Be sure container is fully seated and that drive
coupling is properly engaged. Plug blender cord into outlet.
5. This blender has 2 speed settings: HI (II) and LO (I). Press toggle
switch to desired position. To crush ice, always use HI (II) speed
setting.
6. When finished blending, set toggle switch to OFF (O) position.
7. Allow motor to come to a complete stop before removing
container from blender base. Never place the container
on the motor base or remove it from the motor base while
motor is running.
8. Always hold container with one hand when starting and while
blending. Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and
Sanitizing Instructions.
10. Unplug to turn off all power to blender.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot materials,
the following precautions and procedures must be observed:
1. Limit the amount of material processed to 1/2 pint (235 ml).
2. Completely remove the measuring cup lid insert before turning
on blender. This will allow venting of the rapidly heated and
expanding air present inside container when blender is running.
3. Always start blending on lowest speed setting, then progress to
desired speed.
4. Never stand directly over blender when it is being started or
while it is running.
6