Greenlee G6 Turbo Manual De Instrucciones página 37

Puller Operation (cont'd)
Wire Pulling up to 6000 lb (26.7 kN) with
Main Capstan (cont'd)
8. Position yourself so that you can see the force
gauge indicator lights. Refer to the table below.
Force Gauge Indicator Lights
State of
Pulling Force (lb)
Force Lights
0–3900 (low)
Solid Green
0–1950 (high)
Flashing Green 1950–2400 (high)
Yellow 3900–5400(low)
Red Over 5400
9. Grasp the tailing end of the rope. Apply a slight
amount of tailing force.
10. Start the puller by pressing and holding down the
foot switch.
11. Tail the rope, allowing the spent rope to accumulate
on the floor between the operator and the puller.
12. When the pull is complete, turn the puller OFF.
Tie off the rope and anchor the cable.
Greenlee Inc.
Duty Cycle
Continuous
Change to low
5 ON/10 OFF
STOP
37
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
G6 Turbo™