Electrical Connection; Intended Use; Using For The First Time; Operation - GUTFELS COFFEE 3010 Manual De Instrucciones

EN

9.5 Electrical connection

WARNING
Electric shock due to faulty
connection
The appliance must be switched off when
connecting it to the mains power supply.
The switch must be set to '0'.
Check the mains voltage against the
✓
specifications on the type plate.
You will find the information on
o
this on the type plate of the
appliance.
Connect the mains power cable to a
✓
properly installed grounded plug
socket.

Intended use

9.6
The coffee maker is exclusively for the
preparation of coffee. The coffee maker is
intended exclusively for use in private
households and is not suitable for
commercial use.
Use the coffee maker only as described in
this instruction manual. Any other form of
use does not constitute an intended use
and can result in material damage or even
personal injury.
The manufacturer or dealer accepts no
liability for damage or injury resulting
from improper use or use for other than
the intended purpose.
For safety reasons, modifications or
alterations to the appliance are not
permitted.

10 Using for the first time

Before using the appliance for the first
time, clean it with a damp cloth.
Setting up the coffee maker
• Place the appliance on a flat and stable
surface.
• Insert the mains plug into a socket with
protective contacts.
Before the first brew
• Run 2 times with clean water only and
without paper filter to remove dust
accumulated during production.
• Under no circumstances use coffee powder
for this cleaning cycle.
Page | 14

11 Operation

To operate the appliance, proceed as
follows:
1.
Open the water tank cover.
2.
Fill cold water into the water tank
according to the desired number of
cups.
→ Fill the water tank up to the
"MAX" mark.
3.
Make sure that the filter holder is
inserted.
4.
Bend the bottom fold of the paper
filter (size 1x4).
→ The paper filter must not
protrude over the edge. Press
down a little with your hand.
5.
Insert the filter into the filter holder.
6.
Fill the filter with the desired amount
of coffee powder.
7.
Fold down the filter/water tank cover.
8.
Place the thermos jug on the plate.
9.
Switch on the appliance.
→ The control light in the
switch lights up.

IMPORTANT

The brewing process takes about 8-12
minutes.
Automatic switch-off
After switching on, an automatic switch-
off function ensures that the appliance
does not overheat.
The appliance switches off after 40
minutes.
Premature shutdown is possible by
pressing the on/off switch.