Safety Symbols; General Safety - Fluke touch device Informacion General

This safety and general information document contains safety and
information symbols that are relevant while using the system. The
document contains detailed laser safety information. The following
handling aspects are also dealt with: storage, care, maintenance,
disposal and transport. Safety specifications, FCC requirements, notes
on data storage, general information, and system warranty form part
of this document.
Contents subject to change without further notice, particularly in the
interest of further technical development.
Safety

Safety symbols

The CAUTION symbol denotes information which must
be followed in order to avoid damage to equipment.
The WARNING symbol denotes information which must
be followed in order to avoid personal injury.
The laser safety warning symbol denotes laser radiation.
The Electrical hazard symbol is used to identify
electrical hazard and high voltage areas.
Denotes conformity to requirements of European Union
and European Free Trade Association.
Denotes that any waste electrical and electronics parts
of the system including memory sticks must be disposed
of according to applicable safety and environmental
regulations.
Denotes that the product is made of parts that are
recyclable.

General safety

To prevent possible electrical shock, fire, or personal injury:
 Read all safety information before you use the system.
 Carefully read all instructions.
 Use the system only as specified, or the protection supplied by
the system can be compromised.
 Make sure machines are locked out, tagged out, and cannot be
started accidentally or deliberately during maintenance.
 Do not use the system around explosive gas or vapour.
 Use only the external mains power supply included with the
system.
 Do not charge the system while inside its carrying case.
 Do not use the system if it operates incorrectly.
 Use only specified replacement parts.
 Have an authorized PRÜFTECHNIK service center repair the
system.
WARNING