Fcc Requirements - Fluke touch device Informacion General

sensALIGN 5 sensor approvals
Brazil
Canada Contains IC: 5123A-BGTBT121
China CMIIT ID: 2016DJ3472
Europe
India ETA Certificate No: ETA-1503/17-RLO(NE)
Approval granted
Indonesia Cert-No: 46667/SDPPI/2016 Client-ID: 5581
Japan
Russian
Federation
Singapore Complies with IDA Standards N2154-16
South Korea
Thailand Approval granted
Turkey CE marking is adequate
UAE REGISTERED No: ER39483/15
DEALER No: DA43636/15
USA Contains FCC ID: QOQBT121

FCC requirements

A) User information according to FCC15.21
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
B) Statement for Class B digital device according to FCC 15.105
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
 Consult the dealer or an experienced radio/ TV technician for
help.