Guarantee And Technical Assistance; Safety Measures And Requirements - FAR KJ 45/S Traducción De Las Instrucciones Originales

INSTRUCTIONS FOR USE I
INDEX
GUARANTEE AND TECHNICAL ASSISTANCE ............................ 12
SAFETY MEASURES AND REQUIREMENTS ............................. 12
TOOL IDENTIFICATION ............................................................. 13
GENERAL NOTES AND USE ...................................................... 13
MAIN COMPONENTS ................................................................ 13
TECHNICAL DATA ..................................................................... 13
AIR FEED ................................................................................... 14
PRELIMINARY OPERATIONS .................................................... 14
PLACING OF THE INSERT ......................................................... 15
WORKING PROBLEMS ............................................................. 16
CHANGE OF SIZE ..................................................................... 17
ADJUSTMENT OF TIE-ROD/HEAD UNIT ................................... 18
TOOPING UP THE OIL-DYNAMIC CIRCUIT ............................... 19
MAINTENANCE ........................................................................ 19
DISPOSAL OF THE RIVETING TOOL ......................................... 19

GUARANTEE AND TECHNICAL ASSISTANCE

FAR riveting tools are covered by a 12-months guarantee.
The period of guarantee starts from the date of delivery
specified on the invoice or delivery note.
The guarantee covers the user/buyer when the tool is bought
through an authorized dealer and only when it is employed for
the uses it was conceived for. The guarantee is not valid if the
tool is not used or maintained as indicated in the instruction
and maintenance handbook.
In case of defects or faults FAR S.r.l. undertakes only to
repair and/or replace the components it considers faulty.

SAFETY MEASURES AND REQUIREMENTS

CAUTION!!!
All the operations must be done in conformity
with the safety requirements, in order to avoid
any consequence for your and other people
security and to allow the best tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact FAR s.r.l.
authorized service centers and use only original spare parts.
FAR s.r.l. may not be held liable for damages from defective parts
caused by failure to observe what mentioned above (EEC directive
85/374).
The list of the service centres is available on our website
http://www.far.bo.it ( Organization )
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when using the
tool.
• Use equipment recommended in the maintenance chapter to do
any maintenance and/or regulation of the tool.
• For topping up the oil, we suggest using only fluids in accordance
with the features specified in this working book.
• If any drop of oil touches your skin, you must wash with water
and alkaline soap.
12
All manuals and user guides at all-guides.com
GB
• The tool can be carried and we suggest putting it into its box after
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the tool
• A safety balancer is suggested when it is possible.
• If the A-weighted emission sound pressure level is more than
• The workbench and the work surface must be always clean and
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have the
• Do not carry the connected tool by pulling the hose. The hole
• Keep the tools in good conditions; do not remove either safety
• After repairing and/or adjusting, make sure you have already
• Before disconnecting the compressed air hose from the tool
• These instructions must be carefully followed.
Date 01-2011
using.
is not fed.
70 dB (A), you must use some hearing protections (anti-noise
headset, etc.).
tidy. The untidy can cause damages to people.
correct size to be used.
must be far from any heating sources or from cutting parts.
parts or silencers.
removed the adjusting spanners.
make sure that there is no pressure in the hose.
ATTENTION! In case of strong impacts or accidental
falls the machine should be completely overhauled.
KJ 45/S KJ 45/S
Revisione - 03