Uline H-2714 Manual Del Usuario página 2

PC AND POWER CONNECTIONS
1. Choose one method of connecting the scale to your
PC: USB or RS232. (See Figure 1)
USB Cable
• Preferred method is USB if supported in carrier or
shipping software.
• USB connection must be used if scale is to
communicate with multiple carrier or shipping
software programs.
CAUTION! DO NOT connect both USB and RS232
cables at the same time.
2. Turn the scale over and make the PC connections as
follows:
USB
• Plug small end of USB cable into the scale
connector port marked "USB". (See Figure 2)
• Plug large end of the USB cable into the PC. A direct
connection to the computer is required. Do not use
a USB hub.
NOTE: The scale is adequately powered by the
USB port so the Power Supply is not needed with
the USB connection.
Power Scale
RS232
Supply Display
PAGE 2 OF 18
Figure 1
RS232 Cable
Figure 2
PC Connectors
USB
IOIOI A
Make direct
connection to PC.
Do not use PC hub.
SET UP
RS232
• Plug the Power Supply (required with RS232) into the
scale connector port marked "Power Supply". Plug
the small end of the RS232 cable into the scale
connector port marked "RS232". (See Figure 3)
• Connect the large end of the RS232 cable into the
PC port (generally labeled COM 1, COM A or IOIOI)
Plug Power Supply into AC outlet.
NOTE: If you plugged the RS232 cable into the
incorrect PC port, turn off the computer, then
change ports and restart your computer.
Power Scale
RS232
Supply Display
Power supply required for RS232 connection.
GEOCAL LOCATION
The very first time the scale is powered up, if the display
shows "0•0", skip to Software Configuration. If the display
shows "GEo in" (See Figure 4), then enter the GeoCal™
Location Codes as follows:
• Choose the code from the GeoCal™ Location
Capacity: 150 x 0.05 lb / 60 x 0.02 kg
lb kg
Codes chart that best matches your location.
• Press the ZERO
Numbers will repeat.
• Press the UNITS
show "donE". Press the UNITS
scale will reboot. Display will show "0•0".
PC Connectors
USB
IOIOI A
METTLER
0
key to scroll to that number.
0
key to select code, display will
key again and
Figure 3
AC
Outlet
Figure 4
0
TOLEDO
0521 IH-2714