Sleep Function - WowWee FlyTech CRASH FX 4705 Manual Del Usuario

oPeratinG CrasH FX
Reconstructing Crash FX
When you hit an obstacle or try to land, your Crash
FX will break into three pieces: body, wings and tail .
To fly it again you will have to reconstruct it, using
the "Easi-snap" system to hold the parts in place .
Verify that the parts are placed with the painted side
facing up, and the scalloped edge facing the back of
the plane, as illustrated . You can place the parts in any order .
Reattaching the tail rudder
It is possible that the tail rudder may become unattached . To reattach it, verify that the
mark is at the top, then insert thetail rudder into the socket as illustrated . Apply firm
but gentle force .
Back of Crash FX

Sleep function

If the remote controller is on, but unused for about 5 minutes, that is you are not
controlling or charging Crash FX, it will enter Sleep Mode . To reactivate the remote
controller, turn it OFF and then ON again .
If Crash FX does not receive a signal for about 30 seconds the tail rudder will flap
intermittently for about 2 minutes . If it still does not receive a signal it will enter Sleep
Mode . To reactivate it, turn it OFF and then ON again .
7