SANUSLIFE ECAIA ionizer S Manual De Instrucciones página 6

3
Installation (water inlet connection and adjustment of the appliance)
3.1 Using the quick-release fastener
3.2 Temporary connection to the water tap
safety ring
water tap
6
The tap water supply hose (A-6) must
1.
be inserted at least 1 cm into the
quick-release opening.
Attach the safety clip (A-11).
2.
To disconnect the hose from the
3.
quick-release fastener, the tap water
supply hose (A-6) must not be un-
der pressure. Remove the safety clip
(A-11), push the safety ring all the way
back and then pull the tap water sup-
ply hose (A-6) out of the quick-release
opening.
Install the diverter valve with aerator
1.
(A-9) on the water tap.
Connect the tap water supply hose
2.
(A-6) to the diverter valve with aerator
(A-9) and the water inlet (B-11).
The water pressure can be adjusted
3.
with the water fl ow rate regulator (B-3).
Note: The ECAIA ionizer S is only suitable
for cold drinking water!