Simu T3.5EBHZ DC Manual De Instrucciones página 11

END LIMIT ADJUSTEMENT
3
If the installation includes several motors, only one motor should to be powered during this
programming procedure 3.1. It will eliminate interferences with the other motors during the procedure.
3.1- Learning mode:
1- Connect the 12V battery to the motor.
2- Then, connect the 12V solar panel to the motor. Go to next step.
3- Press simultaneously on the "UP" and "DOWN" buttons of the BHZ
transmitter. The motor turns 0.5 second in one direction, then in the
other. This transmitter now commands the motor in unstable mode.
Go to step 3.2.
i
During the first three seconds of running during a Up or Down movement, the motor will operate with
slower speed to ease the limit setting.
3.2- Checking the rotation direction:
a
>>
Press the "UP" button of the transmitter :
a- If the motorized tube runs in the Up direction, move to next stage 3.3.
b- If the motorized tube runs in the Down direction, reverse the rotation direction by pressing the "STOP"
button for at least 3 seconds. The motor will run for 0,5 second in one direction, then in the other direction.
Move to the stage 3.3.
3.3- End limit adjustment:
The end limits of the T3.5EBHZ DC are adjusted in 4 different ways depending on the following conditions :
Bottom slat stop or not, rigid* (V.A.S, Easylink or OctoEasy) or flexible link between the rolling shaft and the
shutter.
A
*V.A.S
Easylink
OctoEasy
1
A
>> OK >> 3.3
b
B
*V.A.S
Easylink
OctoEasy
2
2 s
>> >>
3 s
C
1- Simultaneously press the "UP" and "DOWN" buttons
of a BHZ transmitter. The motor will run for 0.5 second in
one direction and then in the other.
2- Press the "STOP" button for 2 s. The motor will run for
0.5 second in one direction and then in the other. The
operation is completed. Go to step §4.
1
2
3 >>
1
>> OK >> 3.3
D
EN 3/8