Simu T3.5EBHZ DC Manual De Instrucciones página 14

RE-ADJUSTMENT OF END LIMITS AND MODIFICATION OF THE ROTATION DIRECTION (IN USER MODE)
8
The re-adjustment of end limits is automatic every 60 cycles (during 4 cycles) or after a battery
disconnection for the following installation: UP end limit, mounting A and C, DOWN end limit,
mounting A and B.
8.1- Re-adjustment of Up end limit (mounting B and D only):
1
1- Move the motor to the Up end limit previously adjusted in §3.3 with the "UP" button.
2- Press simultaneously for 5 seconds the "UP" and "DOWN" buttons. The motor will run for 0,5 second in
one direction and then in the other direction.
3- Adjust the new position with the "UP" and "DOWN" buttons.
4- Confirm the new position by pressing 2 seconds the "STOP" button. The motor will run for 0,5 second in
one direction and then in the other direction. The new end limit is memorized.
8.2- Re-adjustment of Down end limit (mounting C and D only):
1
1- Move the motor to the Down end limit previously adjusted in §3.3 with the "DOWN" button.
2- Press simultaneously for 5 seconds the "UP" and "DOWN" buttons, The motor will run for 0,5 second in
one direction and then in the other direction.
3- Adjust the new position with the "UP" and "DOWN" buttons.
4- Confirm the new position by pressing 2 seconds the "STOP" button. The motor will run for 0,5 second in
one direction and then in the other direction. The new end limit is memorized.
8.3- Modification of the rotation direction:
Do not move the roller shutter to the up or down end limit position.
1 - Press the "UP" and "DOWN" buttons simultaneously for
5 seconds. The motor runs briefly in one direction, then
in the other.
2 - Within 5 seconds, press the "STOP" button for 2
seconds. The motor briefly runs in one direction, then in
the other. The rotation direction has been changed.
6/8 EN
2
5 s
2
5 s
3
3
1
5 s
5 s max.
4
> 2 s
4
> 2 s
2
> 2 s