Technical Data - Simu T3.5EBHZ DC Manual De Instrucciones

Ocultar thumbs Ver también para T3.5EBHZ DC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Recharge the battery : it is possible to charge the battery directly from the battery connector (DRAWING A),
or from the solar panel connector of T3.5EBHZ DC motor (DRAWING B).
DRAWING A
1
OR
OR
LED GREEN
Ref. 9020638
Ref. 9020638
5
OR
OR

TECHNICAL DATA

11
- Radio frequency 868-870 MHz, tri-band two-way.
- Frequency bands and Maximum power used:
868,000 MHz - 868,600 MHz e.r.p. <25 mW
868,700 MHz - 869,200 MHz e.r.p. <25 mW
869,700 MHz - 870,000 MHz e.r.p. <25 mW
We care about our environment. Do not dispose of the appliance with usual household waste. Give it
to an approved collection point for recycling.
Please separate storage cells and batteries from other types of waste and recycle them via the local
collection facility.
SIMU SAS, F-70100 ARC-LES-GRAY as manufacturer hereby declares that the drive covered by these instructions and
used as intended according to these instructions is in compliance with the essential requirements of the applicable European
Directives and in particular of the Machinery Directive 2006/42/EC, and the Radio Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at www.simu.com.. Bruno STRAGLIATI, Chief Executive, ARC-LES-GRAY, 12/2020.
8/8
EN
LED RED
2
Ref. 9020638
3
OR
OR
6
OR
OR
DRAWING B
1
Ref. 9020638
OR
NiMh : 12V / 2.2 Ah
LED GREEN
5
Ref. 9020638
OR
NiMh : 12V / 2.2 Ah
4
>>
- Do not use the motorization if the
210 min.
battery charger
Max.
motor.
- It is mandatory to de-activate automa-
tic devices (ie: timers, LiveIn, ...) while
loading the battery. Indeed, the transmis-
sion of one order could stop the battery
charging.
- In this case, disconnect the battery
charger from the motor, then reconnect to
complete the battery charging.
- If you need to operate the motor while
loading the battery (only if the battery
7
voltage is more than 12V) :
- Disconnect the battery charger from the
motor to enable the operating.
- After operating, re-connect the battery
charger, to complete the battery
charging.
- Power supply: 12 VDC.
- Operating temperature : - 20 °C to + 60 °C
- Protection rating: IP44
- Safety level: III
4
>>
210 min.
LED RED
Max.
2
6
Ref. 9020638
is connected to the
3
OR
NiMh : 12V / 2.2 Ah
7
OR
NiMh : 12V / 2.2 Ah

Publicidad

Tabla de contenido
loading

Tabla de contenido