FONESTAR ZS-2000M Manual De Instrucciones página 24

EN
EXTERNAL AUDIO INPUTS AND INTERNAL PLAYER
External audio source playing
ZS-4328IO provides 4 auxiliary input ports that can connect to external audio source. The users can set the
interfaces enable or not, the audio source name, multi-case IP address, inputs type through the config
software. The audio source which be connected to the ZS-4328IO through the interfaces, can be broadcasted
in the zones, and these zones were selected through the System Management Software, ZS-200M panel or
ZS-2000M panel. Unlike the normal device such as CD/DVD player which can be connected to the auxiliary
input port directly, the special device such as microphone should be connected to the balance input port,
utilize data - chosen - switches to set the phantom power(DC24V) or input gain of the balance input in the
left.
Internal audio source playing
ZS-4328IO provides 500MB built-in flash memory and 4GB built-in SD card for storing audio files which
can be broadcasted through an Ethernet network. The source can be set through the config software.
FIRE ALARM INTERFACE
According to ZS-4328IO can link to fire alarm system by dry contact or RS-485, the system supports up to
32 ZS-2000M in the same group to enable fire alarm linkage and emergency broadcast. ZS-2000M internal
audio source or the audio source of ZS-4328IO can be selected as the fire alarm voice. The groups which
are related by each trigger signal can be set freely through the config software; the evacuation broadcast and
alert broadcast are selectable. ZS-4328I can link to Notifier fire alarm controller through RS-485 connecting
with LPI-ModBus module.
TELEPHONE INTERFACE
ZS-4328IO can be connected with the telephone interface module through the RS-485 and audio input, to
enable to use telephone remotely select play zones and paging through PSTN switch or VoIP gateway. Max
128 predefined groups of ZS-4328IO can be set through config software.
SOFTWARE CONFIGURATION FUNCTION
The following ZS-4328IO features can be configured through the software:
- Set the playlist
- Set the device parameter
- Device supervision
- Upload configuration and audio files
Configuration data is uploaded to the ZS-4328IO through the network, and the ZS-4328IOI system
automatically reboots so as to allow the configured data to take effect.
FRONT PANEL
1.- POWER: power indicator. When the power supplies normally, the light turns green.
2.- LCD touch screeAC FAULT: indicates the main power supply status.
If this light is turned off, the main power supply is operating normally.
If the light turns yellow, the main power supply has experienced a fault.
3.- DC FAULT: Indicates the backup power supply status.
If this light is turned off, the backup power supply is working normally. If the light turns yellow, backup
power supply has experienced a fault.
- 24 -