Fulbat FLTX20H Manual De Instrucciones página 7

• The charging voltage should never be higher than 15V.
• When charging separately, always remove the battery from the vehicle.
• Current found in the specifications Data.
• If the battery seems hot when touching, stop charging. Allow battery to cool down before
resuming.
• After charging, leave the battery for 1 to 2 hours before checking the voltage.
• If the voltage is less than 12.4V, additional charging is necessary.
INSTALLATION
• Please check the battery state before installation, and charge it if necessary.
• Press test button in order to check the battery voltage and SOC in %.
LCD screen will automatically set off after 10 seconds.
Voltage
13.2 13.0
SOC 100% 90%
• When the battery voltage is lower than 12.8V (80% of SOC), a charge is recommended. When
the battery voltage is lower than 12V (40% of SOC), the battery must be charged.
• Please make sure the electrical system of your motorcycle functions properly before installation.
Please follow steps below:
1. Connect motorcycle red cable to the positive terminal, black cable to the negative terminal,
and then start the motorcycle.
2. Connect a multimeter red cable to positive, black cable to negative. The multimeter will
indicate the battery open circuit voltage.
3. Disconnect positive battery terminal from the motorcycle. The multimeter will indicate the
motorcycle output charging voltage. The charging voltage should be between 14V and 15V. The
battery will not be fully charged if the charging voltage is less than 14V, and the battery will be
overcharged if the charging voltage is above 15V. Either circumstance will damage the battery.
This test should be repeated at 2,000 and 5,000 RPM.
4. Switch off the motorcycle and take out the key. Connect the multimeter (milliamperes
function) between battery and motorcycle cable (either positive or negative terminal) in series.
12.8 12.6 12.4 12.2
80% 70% 60% 50%
12.0 11.8 11.6 11.4
40% 30% 20% 10%
11.2
0%
7