Fulbat FLTX20H Manual De Instrucciones página 8

Then check the motorcycle power consumption in milliamps to make sure the drain current
is less than 1mA when motorcycle is switched off
5. If the motorcycle passes the above tests, FULBAT lithium battery
motorcycle.
• Remove the old battery from the motorcycle.
• Compare the new battery with the old one, and use the attached plastic spacers to adjust the
dimensions if necessary, to make sure new battery can be installed firmly in the battery box.
• By using the plastic spacers, the battery can be installed firmly, and meanwhile it has better
vibration resistance and better heat dissipation.
• Depending of the Lithium battery model, 1 to 3 spacers could be necessary to fit perfectly the
motorcycle battery box.
• The rubber covers on the positive terminal care for preventing battery's short circuit during the
transportation. Please remove them before installation.
• Any questions about the installation or operation, please contact the dealer directly for help.
USAGE
• When use this battery to start a vehicle, each starting time should not exceed 5 seconds, with
an interval of not less than 5 seconds between 2 times starting. Battery should rest at least
3 minutes after a continuous starting of 5 times. Due to different vehicle's performance, we
recommend using a higher capacity battery once the battery is found weak power.
• Keeping the motorcycle's lights on for long time after switching off the engine will over-discharge
the battery, which may result in difficult restarting.
8
can be installed on the