HOMCOM Hs93363 Instrucciones De Ensamblaje página 4

Assembly Instructions
Portable Installation Method: Figure 1
1. Ensure the heater is switched off and unplugged, then turn the heater upside down.
2. Remove the screws from its original hole, then align the mounting holes on the foot with
the mounting holes on the heater body.
3. Insert the three screws and tighten.
4. Repeat these steps for the other feet.
Figure 1
Overheating safety device
If the heater stops working, turn it off and check if the inlet or outlet is blocked. Unplug
the unit and wait at least 15 minutes, so the protection system can reset. If the heater
still does not work, contact customer service for inspection or repair.
Before restarting the heater, ensure it has been unplugged for at least 15 minutes.
Cleaning
1. Always unplug the unit before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum or any other detergent or chemical solvent to clean the heater.
4. When the heater has not been used for a while, store in a clean, dry place, away from
dust and dirt.
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer for
recycling advice.
4