Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
Laser Information
The DCLE34220 2-Dot Cross Line Laser and
DCLE34520 5-Dot Cross Line Laser are Class 2 laser
products. They are self-leveling laser tools that can
be used for horizontal (level) and vertical (plumb)
alignment projects.
This product complies with 21 CFR 1040.10 and
1040.11 except for conformance with IEC 60825-1
Ed. 3., as described in Laser Notice No. 56, dated
May 8, 2019.
Conforms to UL STDS 61010-1 & 2595
Certified to CSA STD C22.2 No. 61010-1
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: DCLE34220, DCLE34520
Responsible Party - U.S. Contact Information
FCC Compliance Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio and television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
ISED Compliance Statement
This device contains license-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science,
and Economic Development Canada's license-
exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation of
the device.
E
13
Publicidad
Tabla de contenido
Solución de problemas
