Installing Your New Appliance - Svan SVR051A Manual De Funcionamiento Para El Usuario

Brief introduction

Installing Your New Appliance

Cleaning before use
• Before using the appliance for the first time,
wash the interior and all internal accessories with
lukewarm water and neutral soap in order to
remove the typical smell of a brand new product,
then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
Installation Positioning
Warning!
Before installing, read the instruction carefully for
your safety and the correct operation of appliance.
• Position the appliance away from sources of
heat such as stoves, radiators, direct sunlight, etc.
• Maximum performance and safety are
guaranteed by maintaining the correct indoor
temperature for the class of unit concerned, as
specified on the rating plate.
• This appliance performs well SN N ST T.
The appliance may not work properly if it is left for
a longer period at a temperature above or below
the indicated range.
Climate class
SN
N
ST
T
Appliances must not be exposed to rain. Sufficient
air must be allowed to circulate in the low rear
section of the appliance, as poor air circulation
can affect performance. Built-in appliances
should be positioned away from heat sources
such as heaters and direct sunlight.
Leveling
• The appliance should be level in order to
eliminate vibration. To make the appliance level, it
should be upright and both adjusters should be
in stable contact with the floor. You can also
adjust the level by unscrewing the appropriate
level adjustment in the front (use your fingers or a
suitable spanner).
Electrical connection
CAUTION
Any electrical work required to install this
appliance should be carried out by qualified
or authorized personnel.
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
WARNING
This appliance must be grounded. The
manufacturer declines any liability should
these safety measures not be observed.
Ventilation of appliance
In order to improve efficiency of
the cooling system and save
energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.For
this reason,sufficient clear space should
be available around the refrigerator.
Suggest: It is advisable for there to be
50-70mm of space from the back to the
wall,at least 100mm from its top,at least
100mm from its side to the wall and a
clear space upfrontto allow the doorsto
open 180°.As shown in follow diagrams.
12