Safety Notices; Electrical Safety; Personal Safety - HammerSmith Multitools M32720 Instrucciones De Uso

use! Retain this instruction manual for future
reference. Should the appliance be transferred to
third parties, so must this instruction manual.

SAFETY NOTICES

1. WORKPLACE SAFETY
• Always keep the workplace clean and well-lit.
Cluttered and poorly lit workplaces increase the
risk of accidents.
• Do not use the device in potentially explosive
areas, such as in the vicinity of flammable liquids,
gases, vapours or dust. The device can generate
sparks, which can ignite dust or fumes.
• Keep children and bystanders clear when
operating the device. Distractions can lead to loss
of control of the device.

2. ELECTRICAL SAFETY

• The plug on the device must be suited to the
socket, and must not be modified in any way. Do
not use adapter plugs with earthed power tools.
This will avoid the risk of electric shock.
• Do not use the device in the rain or in any other
damp environment. If water enters the device, this
will increase the risk of electric shock.
• Always handle the cord with care. Never use the
cord to carry, drag or unplug the device. Keep the
cable clear from heat sources, oils, sharp edges
and moving parts. Damaged or tangled cables
increase the risk of electric shock.
• When using the device outdoors, only ever use an
extension cable that is suitable for outdoor use.

3. PERSONAL SAFETY

• Remain alert and apply common sense when
operating the device. Do not use the device
when you are tired or under the influence of
drugs, alcohol or medication. A brief lapse of
concentration while operating the device could
M32720_HammersmithMultitool_Kreissa ge_Manual_A5_20220629_MM.indd 9 M32720_HammersmithMultitool_Kreissa ge_Manual_A5_20220629_MM.indd 9
result in serious personal injury.
• Always use appropriate protective equipment.
Wear eye protection, a dust mask, safety shoes,
helmet and/or hearing protection that is required
for the respective conditions; these reduce the risk
of injury.
• Avoid unintentional starting of the device. Ensure
that the device switch is in the OFF position before
inserting the battery pack, picking up, or operating
the device. Powering up the tool with the switch
turned to ON can lead to accidents.
• Remove the adjustment key before switching on
the device. If a wrench or adjustment key is left on
the rotating part of the power section, this can lead
to injuries.
• Do not over-tighten the attachment. Always make
sure that you can maintain a strong and balanced
stance. This assures better control in unexpected
situations.
• Do not over-estimate your capacities. Make sure
you have a secure stance and balance at all times.
This allows for better control over the device in
unforeseen situations.
• Wear appropriate clothing. Do not wear loose
clothing or jewellery. Make sure that hair, clothing
and gloves cannot become caught in the moving
parts.
• Adjust the depth of cut to the thickness of the
workpiece. Less than a full tooth of the blade
should be visible underneath the workpiece.
• Always use saw blades with the correct size and
shape (diamond or round) for the holes in the
mandrel. Blades that do not match the fastening
elements will run off-centre and cause loss of
control.
• Never use damaged or non-matching blade
washers or screws. The blade washers and screws
have been specifically designed for your saw to
9
20.07.22 11:40 20.07.22 11:40