Battipav SINTESI 40093 Manual De Instrucciones página 12

GB
the entire length of the tile;
g) raise the cutting lever until the breaker is in the right position;
11
12 h) Apply increasing pressure until the tile separates.
DIAGONAL CUT
• loosen the bracket locking knob;
13
• bring the support bracket to 45°.
• place the tile to be cut on the work surface and proceed with cutting as indicated in paragraph "CUTTING
OPERATION".
USING THE CUTTING INDEX AND THE RELATIVE TILE SUPPORT SHEET IT IS POSSIBLE TO
MAKE DIAGONAL CUTS OF DIFFERENT SIZES.
14
THE CUTTING BRACKET IS EQUIPPED WITH A CM RULER TO READ THE SIZE TO CUT ON
THE SPOT.
15
FOR GREATER STABILITY WHEN CUTTING LARGE SIZE TILES, USE THE SIDE EXTENSIONS.
MAINTENANCE
REPLACEMENT OF THE SCORING WHEEL
16
• Using a 3 mm hex wrench, remove the screw and the scoring wheel locking nut from its seat.
16 • Remove the worn scoring wheel and replace it with the spare one supplied.
Clean the surfaces of any processing residues.
To make the scoring wheel smoother, we recommend lubricating the surface of the locking screw with
lithium-complex grease.
Refit the scoring wheel locking screw and nut.
Always use original BATTIPAV spare parts (Art.492/1).
17
• Adjust the scoring wheel by tightening the screw with a 3 mm male hex wrench, until the side play is
reduced, while also avoiding locking.
ADJUSTMENT OF THE CUTTING CARRIAGE
• Remove any machining residues from the sliding bar of the cutting carriage, without lubricating.
18
• Remove the side play of the carriage by undoing the 3 screws indicated, by means of a 2 mm male head hex
wrench.
• Remove the vertical play of the carriage by turning the vertical adjustment screw
19
• Loosen the locking nuts with an 8 mm socket wrench
19
• Adjust the register with a 2.5 mm male hex wrench
• Tighten the register locking nuts again
20
EXCESSIVE CALIBRATION WILL DAMAGE THE PROPER SLIDING OF THE CUTTING CARRIAGE.
CLEANING
12
Battipav srl