Acqua Brevetti BravoMATIC FT030 Instrucciones De Instalacion Y Uso página 31

A1.7 Characteristics of the water to be treated
BravoMATIC has been designed and built for treating water intended for human consumption in
compliance with Directive 98/83/CE and subsequent amendments.
Warning! BravoMATIC is not designed to filter closed circuit water, process and discharge
water, water containing large quantities of sand or coarse bodies larger than 2 mm, silt or
chemicals (oils, solvents, acids, alkalynes, glycols).
Warning! High chloride concentrations can adversely affect the aggressiveness of the
water and selective corrosion by dezincification of the filters. To remedy the effects of
corrosion, it is advisable that the waters do not have chloride concentrations (Cl
than 200 mg/l.
A1.8 Precautions for use
BravoMATIC is a piece of equipment connected to 220 Volt power supply. The plug
has to be inserted into a standard socket, provided with a ground contact and protected
by a residual current circuit breaker. Check that the plug is firmly inserted into the
socket and located in a protected area, away from accidental contact, water splashes,
humidity and heat sources. To perform any intervention, disconnect the filter from the
power supply.
A1.9 Power supply connection
The power supply is supplied separate and ready to be connected to the filter. Insert the connector
into the terminal block located behind the filter (see following photo). Then insert the power supply
directly into a 230 V socket.
When the filter is switched on, if it is not in the correct position, it performs a maneuver to position
itself in the filtration position.
In the event of a power failure, the filter retains the last programmed setting when it is switched on
again.
BravoMATIC - ENGLISH
MAN139 PAGE E-6
) higher
-