Overview; The Name Of The Charging Station And The Bluetooth - ONEXUS OX1 C Manual Usuario

app operation

Overview

EVSE Master APP is a mobile phone APP for smart charging station,
which is divided into Android and iOS versions. This APP is connected to
the charging station via Bluetooth on mobile phone or WIFI for data
interaction.
Its main function is to monitor the status of the charging station, control
the start and stop of the charging station for charging, set the charging
mode, check and count the charging records, and upgrade the
firmware wirelessly.
The APP uses Bluetooth on mobile phone or WIFI LAN for data commu-
nication. The communication method is to connect through the Bluetooth
channel for the first time, and after setting the WIFI communication
parameters, the WIFI channel communication is performed. When both
communications are valid, the APP automatically switches to WIFI priority.
Note on communication distance. Bluetooth communication is a
point-to-point communication between the mobile phone and the
Bluetooth module of the charging station, and its effective distance is
about 10 meters in an open field; WIFI communication is to make the
mobile phone and the charging station connected to the same WIFI
router, and its effective distance is determined by the signal distance of
the WIFI router, under the condition that both the charging station and
the mobile phone are within the signal range of the WIFI router. No matter
which method exceeds the communication distance, the charging
station cannot be operated.
44
The name of the charging
station and the Bluetooth
The name of the charging station is composed by "ACP#EVSEXXXX",
that is, the prefix "EVSE" plus the last 4 digits of the charging station
number, such as EVSE1234.
The name of the Bluetooth module that comes with the charging station is
"ACP#EVSEXXXX", that is, the prefix "ACP#" plus "the name of the charging
station", such as ACP#EVSE1234.
The default name of the charging station at the factory is "EVSEXXXX",
which is displayed at the top of the APP homepage, indicating which
charging station is currently connected, as well as shown in the upper
left corner of the charging station display. If the two names are
inconsistent, they should be modified again through the page "System
Settings-General Settings-station Name" below.
The default name of Bluetooth module of the charging station is
"ACP#EVSEXXXX" at the factory, which is shown when searching for
available charging stations below, such as ACP#EVSE1234.
When modifying the name of the charging station below, the
corresponding places will also be modified.