Skil PED0900 Manual Del Propietário página 16

d. Insert a 1/4" (6 mm) hex key or metal rod (not included) into the slot in the blade hub to act
as a spindle lock. Use the hex wrench to loosen the nut CLOCKWISE (Fig. 6b).
e. Remove the blade nut, blade retainer,
spindle (Fig. 6c). Check and replace them if they are worn.
Fig . 6b
Hex Wrench
Blade Nut
Spindle lock
Installing the new blade
a. Position the blade hub (removed in step "e"
of the "Removing the blade" section) onto
the spindle with the bulge facing outwards.
Ensure that the slot in the blade hub is
aligned with the groove on the tool to
facilitate the insertion of a 'spindle lock'
(Fig. 6d).
b. Insert a 1/4" (6 mm) hex key or a metal rod
into the slot in the blade hub to act as a
spindle lock (Fig. 6b).
c. Place the new blade onto the blade hub.
d. Mount the outer flange, blade retainer and
the nut onto the spindle, and pre-tighten
the nut COUNTERCLOCKWISE by hand
(Fig. 6e).
WARNING
blade's arbor (Fig . 6c and 6e) . There should
not be any clearance between the blade and
the flat surface of the blade hub .
e. Use the multi-function wrench to tighten the
nut COUNTERCLOCKWISE securely onto
the shaft.
16
The bulge of the blade
hub must engage the
outer flange, blade, and the blade hub from the
Fig . 6c
Fig . 6d
Blade hub
Slot
Groove
Fig . 6e
Outer flange
Blade hub
Blade Nut
Blade Retainer
Outer flange
Spindle
Blade
Bulge facing
outwards
Spindle
Blade nut
Blade
Spindle
Blade
hub
Blade
retainer