Electrical Ratings - Honeywell Home THM5421R1021 Guia De Instalacion

Ocultar thumbs

Contenido

página de 49

/ 49
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

To replace the Equipment Interface Module (EIM)

When you replace an EIM, you must reset the RedLINK accessories before

connecting them to the new thermostat. Follow the instructions below:

At the Portable Comfort Control:

Press and hold the blank space (or arrow) in the lower right

hand corner of the screen until the display changes (hold for

about 4 seconds). Press REMOVE, then YES to disconnect

from the old thermostats. To reconnect the thermostat, go to

Step 4.

At the Indoor Sensor, RedLINK Internet Gateway,

Entry/Exit Remote, Vent-Filter Boost Remote or

Wireless Adapter:

Press and hold the CONNECT button on the accessory until the status light glows

amber (hold for about 10 seconds). To reconnect the thermostat, go to Step 4.

At the Prestige or RedLINK VisionPRO Thermostat:

Go to Installer Options, Wireless Device Manager, Remove Device, and Select

This Thermostat. Follow the prompts on the screen to connect the thermostat to

the new EIM.

At the FocusPRO Thermostat:

Go into Installer Setup and advance to ISU 90. Set that to 1 for do a factory reset.

Specifications

Prestige and RedLINK VisionPRO:

Control for up to 4 Heat/2 Cool heat pump systems or up to 3 Heat/2 Cool conventional systems for

residential and commercial applications.

RedLINKFocusPRO:

Control for up to 3 Heat/2 Cool heat pump systems or up to 2 Heat/2 Cool conventional systems for

residential applications.

Operating Ambient Temperature

Equipment Interface Module: -40 to 165° F (-40 to 74° C)

Operating Relative Humidity

Equipment Interface Module: 5% to 95% (non-condensing)

Physical Dimensions (height, width, depth)

Equipment Interface Module: 9-5/16 x 4-13/16 x 1-19/32 inches (91 x 147 x 42 mm)