KRESS Mission KR233E Manual Del Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
Maintenance
Your Mission
RTK
works hard and needs to be cleaned and checked from time to time. Some parts will
TM
n
require replacement as they become worn. Never use your Mission
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your Mission
1
Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your Mission
and put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
turning disc. Failure to use new screws could cause serious injury.
The Mission
RTK
does not cut grass like other
TM
n
mowers. Its cutting blades are razor sharp on 2 edges
and rotate in both directions for maximum cutting
capacity. Redesigned blade profile better prevents grass
clippings from getting caught in the gap between the
disc and the blade. And with new material, the service
life of each cutting blade will be longer than that of
other brands' when it is programmed to mow every
day. Always check to see if the blades are chipped or
damaged and replace them if they are. When the cutting
blades are dull and worn out, they should be replaced
with the spare blades provided with your Mission
RTK
. Spare blades are also available at your nearest
n
Kress retailer.
A. Replace the blades
Usually your Mission
RTK
TM
replaced every every week, you can adjust the
frequency of replacing the blade according to the
cutting quality of the lawn. When replacing the blades,
make sure to replace all of them at the same time. You
can replace them with one of the spare blade kits and
extra blade screws supplied with your Mission
Before attempting to replace your Mission
blades, turn the power off and put on protective gloves
and follow these steps:
1. Gently flip the Mission
2. Remove the battery cover and remove the battery.
3. Take the 3 screws for fixing disk from each disk off
seperately with a hexagon screwdriver.
4. Remove the two disks.
5. Take the 6 screws for fixing blades off with a
RTK
.
TM
n
TM
's blades need to be
n
TM
RTK
TM
RTK
over.
TM
n
RTK
TM
RTK
.
n
's
n
with defective on/off switch.
n
TM
1
2
RTK
OFF
n
11
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido