Environmental Protection - KRESS Mission KR233E Manual Del Usuario

Troubleshooting
If your Mission RTK does not work correctly, follow the trouble shooting guide below. If the fault persists,
TM n
contact your dealer.
Symptom
The LED light on the charging
base does not turn on.
Mission RTK cannot
TM n
correctly dock with the
charging base.
Machine runs out of power but
does not return to charging
base.
When Mission RTK is going
TM n
downhill, it overruns the
boundary line.
After Mission RTK is turned
TM n
on, the start button is pressed,
but Mission RTK does not
TM n
work.
Mission RTK does not give
TM n
an alarm when it is outside the
Geo fence.
Mission RTK is parked in
TM n
the middle of the obstacle.
Unable to read log
Mission RTK is parked
TM n
around the wall and cannot be
started, and the positioning
light is always on red.

Environmental protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Cause
There is no power.
The magnetic strip is placed in
the wrong direction.
No virtual charging base is
mapped.
The length of the magnetic strip
is less than 2.5 m.
The angle of the border line is
very sharp.
Mission RTK is outside the
TM n
working area.
Poor positioning signal
The software of Mission
itself is not the latest.
Mission RTK is powered off.
TM n
The obstacles around Mission
RTK are relatively small, and
n
Mission RTK fails to get out
TM n
of trouble.
The sensor of Mission
TM
abnormal
The format of U-disk is not
FAT32.
Mission RTK works in the
TM n
shaded area for too long,
triggering the safety protection.
There are too many walls or
trees in the area, blocking the
positioning signal.
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Check if the magnetic strip is placed
in the wrong direction. When correctly
placed, the green stripe of the magnetic
strip is facing away from the charging
base.
Rebuild the map and add the virtual
charging base.
The length of the magnetic strip should
be guaranteed to be greater than 2.5
m.
Try to avoid layout scenarios with sharp
angles.
Move Mission
area.
Find an open place, wait for the
positioning signal light to turn green,
and then press start button.
RTK Update the software of the Mission
TM n
RTK .
n
Turn Mission
TM
TM
Set the area where Mission
easily trapped as No-Go.
Detect Mission
RTK is
n
page on the APP and check the sensor
status.
Convert the format of U-disk to FAT32.
Try to avoid letting Mission
in areas with too much shade.
Solution
RTK inside the working
TM n
TM
RTK on.
n
RTK is
TM n
RTK 's diagnostic
TM n
RTK mow
TM n
15
EN