Troubleshooting - Oster OS-ICMW08EB Manual De Instrucciones

1. Please note, if a power failure occurs due to disconnection of the power cord, or the
power button has been pushed off during an ice making cycle, small ice chips may formed
and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips may be
removed by disconnecting the power cord and gently pushing the shovel to the rear of the
cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the ice to
ice basket. If not, please push the ice shovel gently by finger, then press START/STOP
button to restart.
PROBLEM
The compressor works
abnormally with a buzzing
noise
Water shortage indicator
light is on
Indicator lights on display
are not on
The ice made is too large
and with pieces sticking
together.
The ice making process
was correct, but no ice
came out?
All indicators flash at the
same time
The machine has been
working, but the water has
been warming
When the ice is full, the
machine does not display
the ice full Icon

TROUBLESHOOTING

POSSIBLE CAUSE
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
1.No power
2.Blown fuse
1. Ice of previous cycles left in
the water tray
1.Refrigerant leakage
2.Compressor damaged
3.Fan motor damaged
1.The water box is blocked by ice.
2.The motor is stuck, or the motor
falls off, or the motor is damaged
3. Micro switch damaged
Solenoid broke down
1.Ice full sensor damaged
2.Sunlight interference
English - 9
SUGGESTED SOLUTIONS
Stop the ice maker and do not restart
until the voltage is normal.
1.Add some water until it reaches MAX
position
2.Press POWER button to restart the
machine
1.Turn power on
2.Replace fuse
1.Take out the ice under the stand by
state
Call the service hotline
1.Pull the plug and take out the ice
which under the ice shovel, then plug
in power again, and press the POWER
button. After 3 minutes, the machine
will restart automatically.
2.Call the service hotline
Replace the solenoid valve
1.Replace the ice full sensor
2.Making ice indoor
3.Call the service hotline