Hanging The Fan; Fan Installation - Fanaway EVO2 Manual De Instrucciones

Fanaway EVO2 Installation Instructions
Pass the power supply wires (C) from the ceiling outlet box (B) through the center of the ceiling mounting
bracket (D). Install the ceiling mounting bracket (D) on the outlet box (B) with the mounting screws (F)
provided with the outlet box and washers (E) provided with fan. Fig. 7
Fig. 7
Lift the fan assembly onto the mounting bracket. Ensure the registration slot (A) of the hanger ball is
positioned on the stopper (B) of the mounting bracket (C) to prevent the fan from rotating when in
operation. Fig.8
Light kit installation
CAUTION – To reduce the risk of electric shock, disconnect the electrical supply circuit to the fan before
installing light kit. Ligth kit weight: 1.28 lb.
1. Remove the lamp shade (5) from the lamp base (4) by turning it anti-clockwise.
2. Loosen the screw (1) from the base bracket (3). Align the two slot screws (2) with the keyhole slots of
the lamp base (4).
3. Turn the lamp base counterclockwise until
the slot screws are firmly at the end of the
slots.
4. Secure screw 1 back to the base bracket.
Tighten all three screws. Do not over-
tighten.
5. Connect the upper plug (9) from the fan to
the lower plug (9) from the lamp base
together.
6. Secure the wire protective cover (7) to
lamp base by tightening the screws (8).
7. Install the bulbs (Max. 25W) to the lamp
holders (6)
8. Finally install the lamp shade (5) to the
lamp base by turning it clockwise.
6 | P a g e

HANGING THE FAN

FAN INSTALLATION

Fig. 8
Fig. 9
V2.1 (5/2022)