Cleaning And Maintenance - Remington Blow Dry & Style AS7700 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Create volume using the 50 mm brush
To dry your roots and add volume, place the brush underneath the section close to the
roots and hold for a few seconds, lifting the hair as you dry.
Move the styler downward through the hair section.
Repeat this around the head.
Let the hair cool before further styling.
Create curls and shaped ends using the 38mm and 25mm brushes
To curl the ends in, place the brush underneath the section close to the ends and rotate
the styler inwards allowing the hair to wrap around the barrel and hold for a few
seconds.
To curl the ends out, place the brush on top of the section close to the ends and rotate
the styler outwards allowing the hair to wrap around the barrel and hold for a few
seconds.
38 mm retractable brush - the bristles of this brush can be retracted by twisting the
cool tip. This makes it easier to withdraw the brush from the hair.
Repeat this around the head.
Let the hair cool before further styling.
Create smooth, sleek hair using the paddle brush
Starting at the roots, slowly brush through each section just as you would with a
normal brush.
To add additional volume tip your head upside down and brush the underneath of
your hair.
When dry use your fingers to shape the hair and ends.
Root volume using the root boost attachment
Push the root boost slowly into your roots towards the centre of your head.
Allow the hair to push against the root boost and hold the root boost there for up to 10
seconds.
Repeat until you have voluminous hair.

CLEANING AND MAINTENANCE

After use, turn the appliance off by moving the temperature control switch to the O
position.
Unplug the appliance and allow to cool before cleaning and storing away.
To maintain peak product performance and to prolong motor life, it is important to
regularly remove any dust and dirt from the air filter grille and clean with a soft brush.
To clean the area covered by the grille, twist it in the direction shown (Fig. C) and slide it
down the cable. Clean the inside area then slide the grille back up the cable and twist it
in the opposite direction until it locks.
Don't use harsh or abrasive cleaning agents or solvents.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
RS
UA
BG
AE
5

Publicidad

Tabla de contenido
loading

Tabla de contenido