Isoplam PLAM MIX 120 Manual De Uso & Mantenimiento página 16

INSERT THE FRONT LEGS INTO THE FRAME, AND SECURE THEM
BY INSERTING THE PINS INTO THE DEDICATED ADJUSTMENT
HOLES.
SECURE THE PIN WITH THE DEDICATED SAFETY CLIP (FIG.6).
INSERT THE TWO REAR LEGS WITH WHEELS INTO THE FRAME,
AND SECURE THEM BY INSERTING THE PINS INTO THE
DEDICATED ADJUSTMENT HOLES (FIG.7).
Repairs must be done exclusively by specialised personnel.
strictly prohibited.
Although the machine is constructed in line with established legislation,
certain residual risks cannot be eliminated and require the use of indivi
dual safety equipment. The machine is equipped with notices to indicate
the residual risks and how to avoid them.
Note that the employer is responsible for ensuring his workers use indi-
vidual safety equipment.
Fault
Defective power cable
Plug not inserted in
socket correctly
Power cable from
plug to control panel
detached
Loose wire inside motor
circuit board
Motor does not start
when switch is turned Loose wire inside motor
circuit board
Limit switch malfunction
Faulty main switch
The overload safety
device has been
activated
Tank guard open
-
Blocked outlet guard
Outlet does not open
During mixing, the Belts are worn or slack
blades slow down or jam
* Operation to be carried out by an electrician
16
Cause Remedy
Check power cables *
Ensure correct
connection
Remake the connection *
Remake the connection *
Remake the connection *
Replace limit switch *
Replace switch *
Wait for a few minutes
and then try restarting
the machine
Close tank guard
Remove and clean outlet
guard
Tension or replace the
belts