Carton Contents; Intended Use - sunjoe SJ-BZ15W-BLK Manual De Instrucciones

Unpacking

Carton Contents

• Electric bug trapper
• Replacement glue boards (x10)
• AC adapter
• Power cable
• Cleaning brush
• Manual and registration card
1. Carefully remove the electric bug trapper
and check to see that all of the above items
are supplied.
2. Inspect the product carefully to make
sure no breakage or damage occurred
during shipping. If you find damaged or
missing parts, DO NOT return the unit
to the store. Please call the Snow Joe
+ Sun Joe customer service center at
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton
and packaging material until you are ready
to use your new electric bug trapper. The
packaging is made of recyclable materials.
Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and
packaging material are not toys. Do not
let children play with plastic bags, foils, or
small parts. These items can be swallowed
and pose a suffocation risk!
m
WARNING!
injury, the user must read and understand this
operator's manual before using this product.
Failure to follow all warnings and precautions
may result in personal injury, or property
damage.
Installing Glue Board
1. Peel the paper backing from the glue board
(Fig. 1).
Fig. 1
Glue board
Paper backing
To reduce the risk of
2. Press the tray release button to unlock the
tray at the bottom of the bug trapper. Then
place the glue board with the sticky side up
onto the inside of the tray (Fig. 2).
Fig. 2
Glue board
®
3. Close the tray.
Operation

Intended Use

The SJ-BZ15W-BLK electric bug trapper is
designed to trap and collect various small flying
insects such as mosquitoes, fruit flies, gnats,
moths and more.
This product is intended for indoor domestic
use only. It is not intended for commercial use.
It must not be used for any purposes other than
those described.
Powering the Bug Trapper (Fig. 3)
1. Connect the included power cable into the
USB port of the USB adapter.
2. Plug the USB adapter into an appropriate
electrical outlet.
3. Plug the other end of the power cable into
the power socket on the back of the bug
trapper.
Fig. 3
USB adapter
4
Power
cable
Tray
release
button
Power
socket